Variable-speed heat pump
Runs at low speed for long periods, which mixes air between floors and pulls out more humidity.
In a three-storey Westwood Plateau home the top floor can run several degrees warmer than the basement. We design cooling that reaches the bedrooms, not just the stairs.
No heat, no hot water or a gas smell? Call any time, day or night.
The most common complaint we hear about AC installation in Coquitlam is not that the house is hot. It is that the top floor is hot. Hillside homes on Westwood Plateau, Eagle Ridge and Burke Mountain catch afternoon sun on big west-facing windows, and warm air piles up under the roof. A single thermostat on the main floor is satisfied while the kids' rooms stay muggy.
We fix that at the design stage. That might mean a variable-speed system that runs longer and gentler, an extra return upstairs, a second zone, or a ductless head dedicated to the primary bedroom. For newer Burke Mountain homes, some builders roughed in a line set or left room for a coil, which can simplify the job. We check what is already there before quoting.
Systems chosen around stairs, slopes and sun exposure.
Runs at low speed for long periods, which mixes air between floors and pulls out more humidity.
A coil on your existing furnace and a condenser outside, the familiar route for many 1980s and 1990s homes.
A dedicated mini-split upstairs solves stubborn hot bedrooms without reworking the ductwork.
Adding or enlarging upstairs returns lets hot air actually leave the top floor.
Remote sensors or zoned dampers let the system respond to bedroom temperatures, not just the hallway.
Compact units and careful placement for complexes near the Evergreen line with strata rules.
Coquitlam's housing ranges from 1960s split-levels in Maillardville and Austin Heights to brand new homes on Burke Mountain and towers in City Centre and Burquitlam. Older homes often need a closer look at duct size and electrical capacity. Newer homes tend to have better insulation but large window walls that let heat pour in.
Sloped lots also affect where the condenser goes. We avoid tucking units into narrow side yards where hot air recirculates, and we keep them clear of where snow slides off the roof on the occasional heavy winter.
We note temperatures on each level and look at duct runs to understand where the cool air is going.
We size the equipment for the home and decide whether zoning, returns or a ductless head is needed.
Hillside lots may need wall brackets or a raised pad. Line sets are routed neatly up or down the grade.
After start-up, we adjust dampers and fan settings so each floor lands closer to the same temperature.
We focus on getting cool air upstairs, which is where most complaints come from.
Sizing based on your windows, insulation and orientation.
Sometimes a single ductless head beats a whole new system, and we will say so.
After install, our technicians are on call any time something goes wrong.
Still unsure? Call (236) 222-2222 and talk it through with us.
Heat rises, roof and window exposure is greater upstairs, and many homes have small or missing upstairs returns. A properly designed system with good return air, longer run times or a dedicated upstairs head addresses all three.
Usually. A pre-run line set or a plenum ready for a coil can shorten the install. We test any existing lines for leaks and check they suit the equipment you choose.
For most homes, yes. Winters are mild enough that a modern heat pump handles most heating hours, with the furnace as backup during cold snaps.
A typical central AC or ducted heat pump takes about a day. Adding zoning, returns or upstairs ductless heads can stretch it to two or three.
Call Able Pro at (236) 222-2222 or book online to start planning your installation.
Call or text, 24/7 for emergencies(236) 222-2222We only use your details to arrange your visit.
Thanks! We will call you to confirm a time. Need us sooner? Call (236) 222-2222.