Cold baseboards
Air locks or a weak pump leave far rooms cool. We purge and check flow.
Hot water baseboards are simple and dependable when the boiler, pump and water pressure are looked after once a year. We handle the full system.
No heat, no hot water or a gas smell? Call any time, day or night.
Plenty of Port Coquitlam family homes from the 1970s to 1990s heat with hot water baseboards along the outside walls. These systems are simple: a boiler, a circulator pump, an expansion tank, an air scoop and a run of fin-tube in each room. When one of those pieces falls behind, you notice it as a cold bedroom, a clanking pipe, or a puddle under the relief valve.
Boiler maintenance in Port Coquitlam from Able Pro keeps every piece working together. We service the boiler, test the safety controls, check pressure and air removal, and make sure each baseboard loop gets hot. We also show you the two or three things worth checking yourself between visits.
Most baseboard complaints have a simple, preventable cause.
Air locks or a weak pump leave far rooms cool. We purge and check flow.
Pipes expanding against joists and air in the loop are both easy to address.
Usually caused by high pressure from a waterlogged expansion tank, which we test.
A stuck automatic vent lets air build up, so we check and replace it when needed.
Dust and pet hair on the fins block heat output. We show you how to clean them.
A fill valve that leaks through slowly overfills the system and raises pressure.
Split-levels in Citadel Heights and Mary Hill often have long baseboard runs to the far bedrooms, where air tends to collect. In Oxford Heights, Lincoln Park and Riverwood, two-storey family homes may have separate upstairs and downstairs zones that need checking individually.
Older bungalows in Glenwood and Birchland Manor sometimes still run on their original boilers. We give those extra attention around draft, the heat exchanger and the relief valve.
Book online or call (236) 222-2222 for a time that suits your family.
We clean and test the burner, controls and venting.
We check pressure, purge air and make sure every room heats.
We show you the gauge, the bleed points and what to watch for.
We know these systems inside out, from pumps to fin-tube.
Boot covers, tidy work and a clean mechanical room when we leave.
Any part we recommend is quoted before it is installed.
Our technicians are on call 24/7 for no-heat calls.
Still unsure? Call (236) 222-2222 and talk it through with us.
That room is usually at the end of the loop and often at a high point, so air settles there. A purge and a working air vent usually fix it. If not, we check pump flow and the baseboard itself.
Vacuum the baseboard fins, keep furniture and curtains from covering them, glance at the pressure gauge, and test your CO alarms. Leave gas, burner and valve work to a technician.
No. A dripping relief valve usually means pressure is too high, often from a waterlogged expansion tank or a leaking fill valve. It should be looked at before it gets worse.
Yes, if it is sound. Regular service keeps it safe and efficient, and it tells you early when it is time to start planning a replacement, rather than finding out in January.
Call (236) 222-2222 or book online and keep every baseboard in the house warm.
Call or text, 24/7 for emergencies(236) 222-2222We only use your details to arrange your visit.
Thanks! We will call you to confirm a time. Need us sooner? Call (236) 222-2222.