Colder design temperatures
We size equipment to keep up during multi-day cold snaps, not just average winter days.
Maple Ridge gets colder than the city, and some homes run on propane. We install furnaces sized for local conditions, from Albion to Whonnock.
No heat, no hot water or a gas smell? Call any time, day or night.
Winter in Maple Ridge often runs a few degrees colder than in Burnaby or Vancouver, and outflow winds down the Fraser Valley can push temperatures well below freezing for days. A furnace installation in Maple Ridge has to handle those stretches without running flat out, which is why we size from a heat loss calculation based on your house and local design temperatures, not a rule of thumb.
Fuel is the other big question. Homes in Haney, Cottonwood and Silver Valley mostly have natural gas, while acreages toward Websters Corners and Whonnock may rely on propane. Many furnaces can be set up for either fuel with the correct conversion kit, and we confirm that, along with tank placement and supply line sizing, before quoting.
These local factors come up on most of our jobs east of Pitt Meadows.
We size equipment to keep up during multi-day cold snaps, not just average winter days.
Propane units need the right conversion, regulator and line sizing to burn cleanly.
Longer service runs, outbuildings and older add-ons call for careful planning.
Intake and exhaust pipes are set above expected snow levels so the furnace does not lock out.
A heat pump handles mild days and the furnace takes over when it gets truly cold.
We can talk through wiring that makes running a furnace on a generator safer.
In Haney and the Town Centre, we find a lot of older homes still running their original furnaces, sometimes with ductwork added piece by piece over the years. Newer neighbourhoods like Silver Valley and Albion have modern high-efficiency furnaces, but basement suites and finished spaces often need duct changes.
Further east, around Thornhill, Websters Corners and Whonnock, properties are larger and some rely on propane. Here we pay close attention to fuel supply, longer duct runs and vent placement that stays clear of drifting snow during the colder spells Maple Ridge regularly sees.
We look at the house, fuel supply, ducts and where vents and drains can safely go.
You get a heat-loss-based recommendation and clear pricing for each option.
Old equipment out, new furnace set, connected and sealed, with your floors protected.
We test start-up, combustion and safety controls, and show you what to watch in a snowfall.
We plan for the cold snaps your area actually gets.
We work with both fuels and explain the differences honestly.
Rural homes cannot wait days for heat, and we are on call around the clock.
You know the full scope and price before work begins.
Still unsure? Call (236) 222-2222 and talk it through with us.
Yes. Most furnaces can be configured for propane with the manufacturer's conversion kit. We also check the regulator, line size and tank location to make sure the furnace gets steady pressure.
It means sizing should be based on local design temperatures and your home's heat loss. That often lands close to the right size rather than a much larger one. Oversizing causes short cycling and wear.
It can if the drain line runs through an unheated space or exits outdoors. We route condensate to an indoor drain or protect the line so it keeps flowing in cold weather.
Dual fuel works well here. A heat pump covers mild and wet days efficiently, while the furnace handles the deep cold, which also keeps you comfortable during temperature drops.
After a snowfall, check that intake and exhaust pipes outside are not buried or iced over. A blocked vent shuts the furnace down for safety. We place terminals high enough to reduce the risk.
Call (236) 222-2222 or book a site visit online for a furnace installation sized and vented for where you live.
Call or text, 24/7 for emergencies(236) 222-2222We only use your details to arrange your visit.
Thanks! We will call you to confirm a time. Need us sooner? Call (236) 222-2222.