Pump runs nonstop
A stuck float, a failed check valve or a pump too small for the inflow keeps it running.
Sump pumps
Sump Pump Installation and Repair for Wet Winters
Atmospheric river storms test every sump pump in the region. We install, repair and back up pumps so your basement or crawlspace stays dry when it counts.
- New and replacement pumps
- Battery backup systems
- 24/7 flood response
No heat, no hot water or a gas smell? Call any time, day or night.
WATER SERVICE ยท Schematic
- 24/7 emergency service
- Tri-Cities, Burnaby, Surrey, Pitt Meadows, Maple Ridge
- Clear quote before work starts
- Tidy, respectful work
- Furnaces and boilers
- Air conditioning
- Heat pumps
- Water heaters
- Book online in about a minute
Overview
Sump pump installation and repair that holds up to BC rain
A sump pump sits in a pit at the lowest point of a basement or crawlspace and pumps out groundwater collected by perimeter drains. In Metro Vancouver, where winter storms can drop heavy rain for days and many homes in Maple Ridge, Pitt Meadows and low-lying parts of Surrey sit on high water tables, the pump may cycle constantly from November to March. Our sump pump installation and repair service keeps that system reliable.
The weak points are predictable: a float switch that sticks, a check valve that lets water fall back, a discharge line that freezes or clogs, and a pump that fails during a power outage, which is when storms often hit. We size pumps to the inflow, install sealed lids and proper check valves, and offer battery backup or high-water alarms so you are not relying on luck.
Sump pump problems and upgrades
Most failures give warning signs, if you know what to listen for.
Pump hums but no water
An impeller jammed with debris or a seized motor means water is not leaving the pit.
Pump is over ten years old
Older pumps often fail without warning, usually during the heaviest rain of the year.
Battery backup pumps
A secondary pump on a deep-cycle battery takes over when the power goes out.
High-water alarms
An alarm or smart sensor alerts you before water reaches the basement floor.
Discharge line issues
Clogged, frozen or poorly routed discharge pipes can send water straight back to the foundation.
Included
Test your sump pump before the rainy season
- Pour a bucket of water into the pit and watch the pump start
- Make sure it shuts off once the water drops
- Listen for grinding or rattling during operation
- Check the outdoor discharge is clear and away from the house
- Confirm the pump is on its own outlet, not an extension cord
- Test the backup battery and alarm if you have them
- Clear silt and debris from the bottom of the pit
How it works
Our sump pump process
- 1
Assess the pit
We check the pit, inflow rate, pump age and how water discharges.
- 2
Size the pump
We choose a pump for the volume and lift, plus backup options that suit your home.
- 3
Install properly
New check valve, secure discharge, sealed lid and a dedicated power source.
- 4
Test under load
We fill the pit to confirm start, stop and backup operation before leaving.
Why trust Able Pro with your sump
On call during storms
Pumps fail at night in the worst weather, and our technicians answer 24/7.
Backup-first thinking
We help you plan for power outages, not just the next pump replacement.
Right-sized equipment
A pump that matches your inflow lasts longer than one that short-cycles.
Clean basement work
Pit work is messy, so we protect floors and clean up afterwards.
Related services
PlumbingFrom a dripping shut-off valve to a failed water heater or a flooded crawlspace, our plumbers handle the water side of your home...Plumbing and DrainsGurgling toilets, a floor drain that backs up after laundry, a basement that smells like sewer: we clear the blockage, then show...Backflow PreventionA backflow preventer stops irrigation water, boiler chemicals and other contaminants from being drawn back into your drinking...Cross ConnectionA garden hose sitting in a bucket of weed killer is a cross-connection. So is a boiler fill line without protection. We find...Drain CleaningPlunging moves a clog a few centimetres. Professional drain cleaning scours the pipe wall so water runs freely again and stays...
Questions homeowners ask us
Still unsure? Call (236) 222-2222 and talk it through with us.
How long do sump pumps last?
Many pumps last around seven to ten years, depending on how often they cycle. Homes on high water tables wear pumps faster. If yours is approaching that age, replacing it before the rainy season is cheaper than dealing with a flood.
Do I need a battery backup sump pump?
If your home relies on a sump to stay dry, yes. Winter windstorms often knock out power during heavy rain, which is exactly when the primary pump is needed. A backup pump on a charged battery covers that gap.
Why does my sump pit smell?
A dry pit or stagnant water can produce odours, and an unsealed lid lets them into the house. A sealed, gasketed lid and occasional cleaning usually solve the smell.
Can my sump pump discharge into the sewer?
Most Metro Vancouver municipalities do not allow groundwater to be pumped into the sanitary sewer. Discharge usually goes to the storm system or a suitable area on the property, depending on local rules.
What does a high-water alarm do?
It sounds an alert, and in some models sends a phone notification, when water rises above a set level. That gives you time to act before the floor floods.
Book your visit
Do not wait for the next storm
Call (236) 222-2222 or book online to check, replace or back up your sump pump.
Call or text, 24/7 for emergencies(236) 222-2222Request a visitTakes about a minute
We only use your details to arrange your visit.
Request received
Thanks! We will call you to confirm a time. Need us sooner? Call (236) 222-2222.